Then remove the 4 7 mm headed screws that host the liner to the dash; two on each side.

You are watching: How to replace blower motor 1995 chevy truck

*

The silver box is the PCM and underneath that is the foam and rubber cover that has to be removed. Over there will usually be a fair amount the dust on every little thing in this corner of the dash. This one also has a good bit that hair native a dog. I offered my shop vac to remove the worst of the hair and also dust.

*

With the clips eliminated the PCM can be positioned to make it simpler to remove the harness connectors. Although the PCM is reasonably rugged that is ideal to treat it as delicate as possible. Make sure you boring the latches and pull the harness connectors directly out. When the harnesses room disconnected, the PCM can be gotten rid of from the gloves box opening.

*

The 2 on the front sheet only need to be loosened to remove the bracket.

*

At this suggest the wires can be disconnected native the blower motor. The ground wire has actually a latch that has to be depressed. You can likewise remove the two front screws that held the PCM parentheses in place. It provides it slightly less complicated to remove the cover.

*

Now the peak edge can be lifted up and also off the the hooks.

*

Now eliminate the screws form the sill key (sorry no picture) and then remove the appropriate kick panel cover.

*

Use a pry bar to totally free the bracket kind the pivot pin.

*

Go approximately the outer edge that the blower motor and remove the mounting screws. Carry out not eliminate the grounding tab screw at this point. Girlfriend will additionally need to remove the tiny rubber hose the connects between the side of the blower motor and the pipe on the blower case. This water tap is very important come the life the the blower motor. Do Not shed it and DO psychic to download it ~ above the brand-new motor. It uses some of the waiting from the blower case and also directs it into the blower windings to save the blower motor cool.

*

Be sure to clear the blower case and the evaporator fins of every debris before reassembling. I provided my shop vac through a small hose attachment.

*

Remove the paint from the area wherein the grounding tab will be mounted on the brand-new motor.

*

Note the vent hole on the old blower motor.

*

Reassemble the blower motor right into the dash and also install all eliminated parts. The peak two screws that room in recesses in the PCM mounting key cane be an overwhelming to start. I sue a little trim adhesive ~ above the screw head to host the screw into a socket. This renders it much easier to install. Likewise remember to download the 2 screws in the front leaf of the bracket, earlier onto the blower case, prior to the bracket is installed. That way all you need to do is tighten lock up. Much easier than make the efforts to download them with everything earlier in place.

See more: How Much Is A Tub Of Ice Cream, 3 Gallon Tub, Great Value Vanilla Ice Cream, 1 Gallon Pail

*

This one is a major power supply for the ignition switch, if i remember correctly.

*

Make certain you take the time to appropriately install every one of the gotten rid of parts. Now the blower motor will job-related with minimal noise.